Thermal adsorption dryer

③ Make the regas flow through the adsorption bed continuously for a specified time, and may be close to saturation before leaving the tower. 1. Adopt large capacity design to ensure that the outlet of the device has a stable outlet dew point, which can adapt to the aging of the adsorbent and the change of operating load;
2. The main key components are selected from well-known brands at home and abroad to ensure the continuous and reliable operation of the device;
3. The whole assembly leaves the factory, so that the installation of the device is simple;
4. Adopt PIC microprocessing control technology to make the device advanced.
Non-thermal adsorption dryer is optional
1. Molecular sieve
2. Dew point switch mode
3. High dew point alarm, interlock
4. The front and rear filters are installed on the whole machine
5. PLC LCD display
6. Configure the communication interface of the upper computer
Technical parameters of non-thermal adsorption dryer
1. Inlet temperature: ≤45℃
2. Handling capacity: 0.7-510 m3/min
3. Working pressure: 0.4-1.0Mpa
4. Pressure dew point: -40 ℃~ -70℃(PDP)
5. System pressure drop: ≤0.02Mpa
6. Gas consumption: 14.5%
7. Switching cycle: 5-10 min (adjustable)
8. Adsorbent: activated alumina
9. Voltage: 220V/1PH/50H