How to provide nitrogen machine with air compressor

How to match the nitrogen machine with the air compressor: You should first consider the system parameters of your nitrogen machine to match the air compressor, and the pressure, flow rate, temperature and so on. There are many aspects to consider. It is best to know the parameter requirements of the nitrogen machine to match the air compressor, but the selection of air compressor must be larger than the required flow of your nitrogen machine system.

General system: The air compressor comes out to connect to the intake tank, the air tank comes out to connect to the cold dryer and then into the nitrogen machine, and then comes out to connect to the working equipment to the nitrogen machine supporting the air compressor is actually very simple, mainly depending on the purity of nitrogen you need, the higher the purity of the air required greater, so that the power of the air compressor is larger, on the contrary, the general purity of 99% nitrogen nitrogen machine on the market most choose 3: 1 is equipped with nitrogen flow rate of 50 cubic meters per hour, the air compressor needs to treat 150 cubic meters of air, the general air compressor manufacturers marked by the air treatment capacity is marked by minutes or hours, the conversion can be done, as for the pressure of compressed air, the general nitrogen machine 0.8MPa

Need to know your nitrogen machine parameters. If it is psa nitrogen production, the amount of compressed air: nitrogen =7:1; If it is cryogenic nitrogen production, the amount of compressed air: nitrogen amount =3:1, the pressure of conventional compressed air is 0.85MPa, the dew point is less than -20℃, and there is no oil.