Compressor installation safety precautions used in nitrogen making machine
The compressor used in the nitrogen generator shall be installed in accordance with the relevant local laws and regulations, and strictly comply with the following provisions:
1. The compressor should be lifted by lifting equipment with a load-bearing capacity greater than the weight of the unit, and the lifting speed and acceleration should be limited within the permitted range.
2, try to install the compressor in a cool, clean, well-ventilated place to ensure that the air inhaled by the compressor is clean and the moisture content is minimal.
3, the air inhaled by the compressor is not allowed to contain combustible gases and corrosive gases, so as not to cause explosion or internal rust.
4, the air-cooled machine should have an exhaust fan or duct to export the hot air outdoors to avoid hot air circulation to the air intake.
5, compressor sewage, waste oil discharge should comply with the provisions of the local environmental protection department.
6, this machine uses three-phase AC power supply 380V, 50Hz, the power supply line to guide the compressor must match its power and install the air switch;
Fuse wire and other safety devices, in order to ensure the reliable safety of electrical equipment, must be reliably grounded.
The normal use of the nitrogen machine is inseparable from the clean compressed air, so the correct use of the compressor is very critical.